Table of Contents
Advertisement
Check_MK rail2 Mark I - Manual
47 / 57
You can now perform the
firmware update
on this node, as on standalone devices also.
After you have successfully performed the firmware update, open the cluster page once more and remove
the maintenance state of the updated device. The device will then automatically merge into cluster
operation, upon which the cluster becomes fully functional again.
It is recommended to run the same firmware version on both nodes. You should therefore repeat the
same procedure for the other node next.
©Copyright Mathias Kettner GmbH 2018
mathias-kettner.de
Advertisement
Table of Contents
Need help?
Do you have a question about the Rail2 Mark I and is the answer not in the manual?