Table of Contents
Advertisement
Check_MK rail2 Mark I - Manual
43 / 57
On the following page, you can connect the two devices to form a cluster. To do this, you need to enter
the password of the web interface of the second device. This password is used once to establish the
connection between the two devices. Then confirm the security prompt if you are sure that you want to
overwrite the data of the target device with the IP address displayed.
Once this connection is successful, cluster setup is commenced. You can have the current status dis-
played on the cluster page.
©Copyright Mathias Kettner GmbH 2018
mathias-kettner.de
Advertisement
Table of Contents
Need help?
Do you have a question about the Rail2 Mark I and is the answer not in the manual?