Table of Contents
Advertisement
Check_MK rail2 Mark I - Manual
39 / 57
The Advanced mode is required for clustering. In order to activate this mode, click on the button Ad-
vanced mode at the top and confirm the security prompt.
All network interfaces available in the device will be shown to you on the following page. Only the
interface eth0 (corresponding to LAN1 ) will currently have a configuration, which was applied by the
Basic mode.
Now create the first bonding interface bond0 by clicking on Create bonding. For this purpose, enter into
the dialogue that follows all data as shown in the diagram below and confirm the dialogue with Save.
©Copyright Mathias Kettner GmbH 2018
mathias-kettner.de
Advertisement
Table of Contents
Need help?
Do you have a question about the Rail2 Mark I and is the answer not in the manual?