HELI G Series Operation & Service Manual page 121

f) Install the drive gearon the pump
body with the side of the spline
downward.
g) Install the driven gear on the pump
body as the direction shown in Fig. 5-34.
h) Install the lining plate on the
side of the gear, don't confuse the inlet oil
port and the outlet oil port.
i) Install a new seal ring and a new
ring on the groove of the rear cover. Apply
lubricating grease on the seal ring.
j) Install the rear cover on the pump
body with it's seal ring downward, don't
confuse the inlet oil port and the outlet oil
port.
k) Tighten up the connecting bolts
with a specified torque of 9 to 10kg.m
after all.
Fig. 5-33
Fig. 5-34
Fig. 5-35
Fig. 5-36
Fig. 5-37
Fig. 5-38
118