Safety And Warnings - Fisher & Paykel 7 Series Installation Manual

Electric Shock Hazard
Failure to follow this advice may result in
electric shock or death.
• Installation and electrical wiring must be
completed by qualified person(s) in accordance
with all applicable codes and standards, including
fire-rated construction.
• Always disconnect the appliance from the
mains power supply before carrying out any
maintenance or repairs.
Weight Hazard
Failure to follow this advice may result in
damage or personal injury.
• The appliance is heavy. Please ensure adequate
care is taken when installing the appliance.
• Product weight: 5.8kg.
Cut Hazard
Failure to use caution could result in injury.
• Take care: some edges are sharp.
• Wear gloves to protect against sharp edges.
READ AND SAVE THESE INSTRUCTIONS
2
WARNING!
!
WARNING!
!
WARNING!
!

SAFETY AND WARNINGS

WARNING!
To reduce the risk of fire, injury to persons or damage when using the appliance, follow the
important safety instructions listed. Read all guidance before using the appliance.
Servicing
Do not repair or replace any part of the appliance unless specifically recommended in the
z
installation or user guide. All other servicing should be undertaken be a Fisher & Paykel
trained and supported service technician or qualified person.
Installation
Please make this information available to the person installing the appliance.
z
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other
z
hidden utilities.
This blower must be installed with a compatible Fisher & Paykel rangehood, failure to do
z
so can void your warranty.
This external blower unit is intended to be installed on the roof only.
z
To comply with electrical safety regulations, the rangehood which controls the blower
z
must be plugged into a socket near the appliance. The socket must be accessible, or have
an accessible isolating switch, to enable the end user to isolate the appliance from the
power for the purpose of internal cleaning or maintenance.
Always switch the power off prior to installation, servicing or cleaning of the appliance.
z
All ducting must comply with local requirements and building codes.
z
Attention should be given to ensure that any applicable regulations concerning the
z
discharge of exhaust air are fulfilled.
To reduce the risk of fire and electric shock, install this appliance only with rangehood
z
models specified.
Ensure the supply cord is not exposed to heat, chemicals or sharp objects. If the supply
z
cord is damaged it must be replaced by a Fisher & Paykel trained and supported service
technician or suitably qualified person in accordance with all applicable codes and
standards, including fire-rated construction.
In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this
z
appliance must not be supplied through an external switching device, such as a timer, or
connected to a circuit that is regularly switched on and off by the utility.
General
Remove all packaging, including protective wrappings, before use.
z
This appliance incorporates an earth connection for functional purposes only.
z
To reduce risk of fire and to properly exhaust air, be sure to duct air outside — Do not vent
z
exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages.
For information on environmental noise limit and conditions please contact your local
z
authority.
The unit cannot be used in conjunction with a recirculation unit.
z