Too List Existing Waypoints; To Create A New Waypoint; To Change An Existing Waypoint - Humminbird NS25 Operation Manual

2. Use cursor to select destination waypoints from list, then select GOTO. You may select
multiple waypoints in the sequence you wish to travel. Each selected waypoint is assigned a
sequential number to identify its place in the temporary route. You may deselect a waypoint
by highlighting a flagged waypoint, then selecting the "?" icon.

Too list existing waypoints:

1. Highlight List, select Yes to display Waypoint List.
2. The first waypoint listed displays in the active menu, scroll down the list to make other
selections and view waypoint information. Select Show to display the waypoint and your
present position on a map.

To create a new waypoint:

1. Highlight Create, then select Yes to display the Create Waypoint screen.
2. The Enter Latitude menu displays. Scroll through the number fields to enter appropriate
numbers, then select OK when finished.
3. The Enter Longitude menu displays. Scroll through number fields to enter appropriate
numbers, then select OK when finished.
Note: Using the Clear or Menu key to exit at this point will save waypoint information.
4. The Enter Name menu displays. Scroll through letter fields to name the waypoint (name is
limited to 16 characters), then select OK when finished.
5. The Select Symbol menu displays. Scroll through symbol fields to make a selection, then
select OK when finished. Select None if you do not wish to assign a symbol.
6. The Save Waypoint menu displays. Select Yes to save to permanent waypoint list. Select No
to cancel and enter information again.
Note: The NS25 will assign a system number to a new waypoint. This number is not always in the
sequence in which it was created.

To change an existing waypoint:

1. Highlight Change, then select Yes to display the Change waypoints screen. Scroll through
waypoint list to highlight a waypoint. Select Change to initiate procedure.
Note: If the selected waypoint is a temporary waypoint, it becomes a permanent waypoint when
selecting Change.
2. The Change Latitude menu displays. Scroll through digits to make changes, if needed. Select
OK when finished.