Built-In Construction Details - Fisher & Paykel DCS BE Installation Manual/User Manual

Built-in Construction Details

Standard layout for non-combustible cavity
IMPORTANT!
If installing the grill into a non-combustible enclosure, all combustible construction must still be
outside the 18" (457mm) clearance zone. If your island is made of stucco over the top of wooden
studs, the wood can not be inside the 18 inch clearance zone to combustible, even though the stucco
is what is touching the grill area.
Note: the enclosure should have
ventilation holes to prevent gas build-up
in the event of a leak. Refer to ANSI
Z21.58 Standard for Outdoor Cooking Gas
Appliances, Section 1.7 Enclosures For Self
Contained LP-Gas Supply Systems.
CAVITY DIMENSIONS
A Maximum height of enclosure shell
B Depth of enclosure shell
C Minimum depth for hood swing
D Width of enclosure cavity
Standard layout for non-combustible enclosure:
E Height of enclosure cavity
f Depth to gas supply opening
G Height of opening for access doors/drawers
64,5 cm 2 /10 "2 Min. ventilation
H Width of opening for access doors/drawers
on the back side
64,5 cm 2 /10 "2 min
ventilation
left
25,72 cm/
10 1/8 "
INSTALLATION
G
48" Models = 116,2 cm/45 3/4 "
36" Models = 87,6 cm/34 1/2"
46.36 cm/
18 1/2 "
D
C
F
E
H
FIG. 05
35 1/2"
22 3/4"
45 3/4"
10 1/8"
NOTE: If using a backguard
18 1/2" (470)
apron or rear wall, locate
electrical service on the
right hand side for rotisserie
motor connection
9,5cm / 3 3/4" Min. for Lid
57,79 cm/22 3/4 "
10,16 x 10,16cm
(4 x 4 ") opening
for gas supply
line
Note: 4x4" (102 x 102mm)
opening for gas supply line
B
A
Note: the cut-out of each
corner should be a 90°angle
in order for the access doors/
drawers to fit properly.
BE1-48R
Inches (mm)
(902) 35 1/2"
(578) 22 3/4"
3 3/4" (95)
(1162) 34 1/2"
(257) 10 1/8"
18 1/2" (470)
20" (508)
WARNING!
46" (1168)
If installing the grill into
a non-combustible
enclosure, all
combustible
construction must still
be outside the 18 inch
clearance zone. If your
island is made of stucco
over the top of wooden
studs, the wood can not
be inside the 18 inch
clearance zone to
EN
BE1-36R
Inches (mm)
(902)
(578)
3 3/4" (95)
(876)
(257)
20" (508)
34" (864)
13