Table of Contents
Advertisement
2. Condensing Unit
1) Unpack and remove all shipping cartons, tape and packing.
) See the nameplate on the condensing unit. Check that your voltage supplied
corresponds with the voltage specified on the nameplate.
Note: Power to the icemaker is supplied by the condensing unit.
Electrical connections must be installed in accordance with applicable national,
state and local regulations.
3) Remove the front panel and louver panel.
4) Check to insure that the refrigerant lines do not rub or touch lines or other surfaces, and
that the fan blades turn freely.
5) Check that the compressor is snug on all mounting pads.
6) Remove the package containing the accessories from the condensing unit.
C. How to Remove Panels
1. Icemaker
• Front Panel: Remove the screw. Lift up towards you.
• Top Panel: Lift off.
• Side Panel (R): Remove the screw. Pull forward slightly and take off.
• Insulation Panel: Remove the thumbscrews Lift up slightly and pull towards you.
2. Condensing Unit
• Top Panel: Remove screws and lift off.
• Front Panel: Remove screws and lift off.
• Left Side/Rear Panel: Remove screws and lift off. If already installed, first recover
refrigerant, remove line set and electrical connections.
• Louver Panel: Remove screws and lift off.
• Right Side Panel: Remove screws and lift off.
Top Panel
Insulation Panel
Front Panel
Left Side/Rear Panel
Side Panel (R)
Icemaker
Fig. 2
WARNING
Top Panel
Front Panel
11
Right Side Panel
Condensing Unit
Fig. 3
Louver Panel
Advertisement
Table of Contents
