Table of Contents
Advertisement
IMPORTANT SAFETY INSTRUCTIONS!
Installation
Cut Hazard
Take care – some edges are sharp.
Failure to use caution could result in injury or cuts.
Checking for transport damage
After removing the packaging, make sure the product is complete and undamaged and that all
accessories are present. Do not use the appliance if it is visibly damaged. Contact Customer Care.
IMPORTANT!
Before connecting the appliance to the electrical supply make sure that the voltage and
●
frequency listed on the data plate correspond with the household electrical supply. If in
doubt, consult a qualified technician.
The appliance must be properly installed before operation to ensure that no electrical
●
components are accessible. Ensure that power is not supplied to the appliance while
installation work, repairs or maintenance is performed.
Be certain your appliance is properly installed and grounded by a qualified technician.
●
To guarantee the electrical safety of this appliance, continuity must exist between the
appliance and effective grounding system. It is imperative that this basic safety requirement
be met. If there is any doubt, have the electrical system of the house checked by a qualified
electrician. The manufacturer cannot be held responsible for damages caused by the lack,
or inadequacy, of an effective grounding system.
Do not use an extension cord to connect the appliance to electricity. Extension cord doesn't
●
guarantee the required safety of the appliance (danger of overheating).
Before service or maintenance disconnect the power supply by either switching off the
●
main switch and unplugging the unit.
Install or locate this appliance only in accordance with the provided installation
●
instructions.
Installation work and repairs must be only performed by a trained technician in accordance
●
with national and local safety regulations. Repairs and other work by unauthorized persons
could be dangerous and may void the warranty.
Only use original spare parts. Only then can the manufacturer guarantee the safety of this
●
machine.
Never open the outer casing of the appliance. Tampering with electrical connections or
●
components and mechanical parts is dangerous and may cause machine damage.
If the machine is installed in combination with other appliances, a protective base should
●
be installed between the appliance and the unit.
Do not install or use outdoors even if installed in the display cabinet.
●
IMPORTANT!
SAVE THESE INSTRUCTIONS
4 |
COFFEE MAKER INSTALLATION GUIDE
1
SAFETY AND WARNINGS
WARNING!
To protect against fire, electric shock and injury to persons do not submerge the cord or
●
plugs in water or other liquids.
To reduce the risk of injury, do not drape cord over the counter top or table top where it
●
can be pulled on by children or tripped over unintentionally.
Do not let the cord hang over the edge of a table or counter, or touch hot surfaces.
●
Do not operate any appliance with a damaged cord or plug, or after the appliance
●
malfunctions or has been damaged in any manner.
Return appliance to an authorized service facility for examination, repair or adjustment.
●
To disconnect turn the machine off, switch off the main switch then remove the plug
●
from the wall outlet.
Do not allow children and animals to stop or linger near the appliance when it is pulled
●
out of the cabinet.
Do not leave the machine pulled out of the cabinet when it is being used.
●
Do not leave the machine pulled out of the cabinet when it is not needed.
●
Install the machine according to the instructions in the handbook to guarantee there are
●
no spills when it is pulled out from the cabinet.
The rails fixing panel must have a thickness suited to the fixing screws supplied standard.
●
The panel material must be suited to the machine weight of approximately 55lb.
●
Advertisement
Table of Contents
