Table of Contents
Advertisement
Installation
Electrical Connections
Connecting the
Monitor
•
Route the power
cable
to the vehicle's
cigarette lighter
socket
12/24V power
outlet. The cable must not
interfere
with
the safe operation
of
the vehicle.
•
Insert the
small
12/24 Volt DC plug of
the power cable
into
the right side of the
monitor.
•
Plug the 12/24 Volt cigarette lighter plug
into the vehicle's cigarette lighter socket.
Connecting the Camera
A
WARNING
When connecting wires, ensure the circuit
is isolated by disconnecting the negative
terminal on the battery.
•
Ensure correct polarity when wiring the
cables. RED+ BLACK-.
•
Ensure correct polarity when wiring.
•
Wire connections and terminals must
be sealed and waterproof.
The Furrion Vision S Camera System can be
connected to an electrical power source via a
7 Way Connector.
Wiring to running
lights: the camera will
activate when the running lights are switched
on.
Wiring to reverse
lights: the camera will
activate when the vehicle engages reverse
gear.
ConnKUto
- n V l 2 4 V
Po-Supply
Consult the vehicle's service manual for
specific wiring color
code.
C
\ -
{
o -
7 WAY CONNECTION
Running,
__ Q
R•v•n• or
'f
Auxlllary
light•
When wiring this camera directly to a 12V
battery or converter In your RV, use an in-line
switch on the power cable to power on or off
your
camera.
This will enable this camera to
be used when parked without a tow vehicle
connected.
IN-LINE SWITCH
DC POWER SUPPLY
Connecting the Traffic Light
•
Route the power cable to the vehicle's
12V running light. The cable must not
interfere with the safe operation of the
vehicle.
A
WARNING
Never connect the traffic light to a power
source over 12V, damage to the traffic light
may occur.
c
]
@
-
- - - -
-- - - -
--
--
-
-- - -
-- - - - -
-- - - - =--U
_
R _R
-
10
-
N
Advertisement
Table of Contents
