Adjustment Of Flake Size - Hoshizaki F-2000MLH Service Manual

2. ADJUSTMENT OF FLAKE SIZE

To adjust the flake size, change the number of the Cutter Heads on the top of the Auger,
according to the following procedures:
1) Remove the Bolt.
2) Take off the upper Cutter Head of the two (coarse flakes) or set the upper Cutter Head
on the lower (fine flakes). The unit is shipped from the factory with two Cutter Heads.
FINE COARSE
[two Cutter Heads] [one Cutter Head]
3) Secure the Cutter Head(s) by the Bolt.
50