Table of Contents
Advertisement
3
On the Power Plug and Grounding
● It is not a problem to plug in the power cord soon after installing the refrigerator.
● Use a wall outlet exclusively when connecting the power cord. (Alternating current 110V, rated 15A or more)
Preparation for an earthquake has been made
properly?
● It is recommended to fi x the refrigerator to a sturdy wall or pillar using
two "safety belt against overturning for refrigerators".
● Option: "Safety belt against overturning for refrigerators" (Parts No.
R-826CV 300: belt x 1) Contact your dealer for details.
4
Cooling down the inside of the refrigerator
● It may take more than 4 hours through 24 hours to cool well the inside of the refrigerator, depending on
conditions such as the ambient temperature or the storage state of foods.
● Perform 製冰機清潔 (Ice Maker Cleaning) when using the automatic ice making function fi rst.
● A series of ice making operation will start automatically after the inside of the refrigerator is cooled well.
(When using for the fi rst time, it may take 24 hours and more to make ice.)
Transporting your refrigerator (transport for moving)
● Make sure to empty food and ice from the refrigerator. Always
drain water from the water supply container and ice tray.
● Secure the door with tape.
● Lay a protective sheet or cloth to protect the fl oor from damage
and catch remaining water spilled from the refrigerator.
● With a large piece of old cloth underneath, tilt the refrigerator
backward to drain water.
● Use assistance to carry the refrigerator. Make sure to hold the
handles when carrying it.
● See Preparation before use for installing the refrigerator in a
new location.
Pg.36
Caution
● Do not remove the sticker from the back of the refrigerator. This
sticker is necessary to secure the performance and safety.
● Do not remove the plastic parts and label from the bottom part of the
side of the refrigerator.
※ If you wish to install the refrigerator in a hot spring area exposed to sulfi de gas, you may need to apply anti-rust treatment
to the piping. Contact your dealer in advance. Failure caused by gas damage will not be covered under guarantee.
It is recommended to ground the refrigerator
to prevent possible electrical shock.
● Contact your dealer to ground the refrigerator or install an earth
leakage circuit breaker if the refrigerator is installed in especially
damp and humid places.
● Option: "Earth wire (2.5m)" (Parts No. NW-60R6 052)
Never connect the earth wire to the following places:
● Water pipe (Danger of electrical shock)
● Gas pipe (Danger of explosion)
● Telephone line or earth of lightning rod (Danger when lightning strikes)
Earth installation screws
Earth terminal
Earth wire
(Copper wire with diameter of
1.6mm)
Screw x 4
Belt
(attached to belt)
Such as old cloth
Stickers
Plastic parts
Label
Pg.53
Left/Right
37
Advertisement
Table of Contents
