Technical Specifications; Ambient Conditions; Table B-1 Climatic Ambient Conditions - Siemens SIMATIC 6DL1193-6AR00-0AA0 Equipment Manual

Technical specifications

B.1

Ambient conditions

Information on the documentation
Note
Higher-priority documentation
The information for the specific components takes precedence over the information in this
documentation. The statements in the product information always takes precedence over all
other information.
Use in hazardous area
Read section "Special conditions for safe use of the BusAdapter (Page 7)".
Climatic ambient conditions
The following table shows the permissible climatic ambient conditions for the ET 200SP HA
distributed I/O system.
Table B-1 Climatic ambient conditions
Ambient condi‐ Permissible range
tions
Temperature
•
•
Note: No icing
Air pressure
•
•
Relative humidity From 10% to 95%
Max. 95% at +25 °C
BusAdapter for Distributed I/O
Equipment Manual, 10/2021, A5E39261458-AC
Horizontal installation: From -40
°C to max. temperature (see
comments)
Vertical installation: from
-40 °C to 60 °C
From 1 080 hPa
(corresponds to a depth of ap‐
proximately -1 000 m)
Up to 606 hPa
(corresponds to an elevation of
approximately 4 000 m)
Comments
Observe any load-dependent limitations.
Refer to the documentation of the employed component.
The maximum permissible upper temperature depends on the
BusAdapter used.
Tested according to IEC 60068-2-2 (Dry heat)
The cooling effect of air depends on the density of the air. The
locally occurring air pressure (operating altitude) might restrict
the maximum permissible ambient temperature. The density of
the air decreases with increasing altitude.
The cooling effect of air corresponding to the typical operating
altitude is shown in the following derating table.
Without condensation, corresponds to relative humidity (RH)
stress grade 2 in accordance with IEC 61131 part 2
Tested according to IEC 60068-2-78 (Damp heat)
B
39