Getting Started - Linear Acoustic AERO.100 User Manual

AERO.100 User Guide

3.5 Getting Started

3.5 Getting Started
3.5 3.5 Getting Started Getting Started
This user guide is intended to be read while in front of a running AERO.100 unit. It is most
helpful if the source(s) that will be used is actually connected to the AERO.100. Doing this
provides feedback to the user, via the meters and IP audio monitoring, about the configuration
changes being made.
To make learning your way around the AERO.100 as useful and rewarding as possible there is
some information that you should have at hand:
• The IP address and subnet mask to be assigned to the AERO.100.
• Any gateway and DNS information for the network to which it will be attached.
• NTP server address(s)
• The IP address of the PC that will be used to connect to the AERO.100.
• Knowledge of where the source audio program(s) are embedded in the SDI source.
• Knowledge of where the loudness controlled audio program(s) need to be embedded in
the SDI output.
Having this information will allow you to configure the unit for use as you learn to navigate the
AERO.100 using NfRemote.
Note!
Newer software versions of AERO.100 REQUIRE A PASSWORD to
sure that a password has been entered in your AERO unit before upgrading to
version 3.14.26 or higher. Saving an empty password field (or restoring a
configuration that does not have a password) will prevent any further access to
the unit. The unit must be returned to the factory to restore a password.
Even experienced users should look at Section 7 Configuration Check List. This contains a brief
description of all of the items that need to be configured for typical use.
Section 9 Special Features, describes some of the special processing features that are part of
the AERO.100 and where to find them.
If you are a new user, please register on the Linear Acoustic website at
www.linearacoustic.com. Click the Log In button and follow the instructions there. One benefit
©2016 TLS Corp. ALL RIGHTS RESERVED Oct 2016
operate. Be
Page 22