Advertisement
Only use the appliance for its intended
l
domestic use. Kenwood will not accept
any liability if the appliance is subject to
improper use, or failure to comply with these
instructions.
before plugging in
Make sure your electricity supply is
l
the same as the one shown on the
rear of your handmixer.
Important – UK only
The wires in the cord are coloured
l
as follows:
Blue = Neutral, Brown = Live.
The appliance must be protected by
l
a 3A approved (BS1362) fuse.
Note:
For non-rewireable plugs the fuse
l
cover MUST be refitted when
replacing the fuse. If the fuse
cover is lost then the plug must
not be used until a replacement
can be obtained. The correct fuse
cover is identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut
l
off it must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
This appliance conforms to EC
l
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
before using your handmixer
for the first time
Wash the parts see 'care and
l
cleaning'.
key
a speed switch
b tool release button
c beaters
d cord wrap
e kneader with additional collar
f kneader without additional collar
g work top storage unit
h beater storage pillars
i kneader storage pillars
j cord tidy
to use your handmixer
1 Unwrap the cord from the cord
wrap d and make sure the speed
switch a is in the off "O" position.
2 Insert the beaters or kneaders 1 –
turn and push until a positive click is
felt.
Important: The kneader with the
additional collar e will only fit into
the larger socket.
3 Plug in.
4 With the ingredients in a bowl of an
appropriate size, place the beaters/
kneaders into the bowl.
5 Pull the speed switch a backwards
to reach the desired speed (the first
dot on the handmixer body is the
slowest speed setting). Line up the
dot on the side of the speed switch
with the corresponding speed.
As the mixture thickens, increase
l
the speed.
If the machine starts to slow or
l
labour, increase the speed.
Move the speed switch forwards
l
to the pulse "P" position to operate
the motor at maximum speed. The
motor will operate for as long as the
pulse is held in position.
3
Advertisement
