Table of Contents
Advertisement
GT-225I
Check idle speed and reset if neces-
sary. If a tachometer is available,
idle speed screw (A) should be set
to the specifications found on "Spec-
ifications" page of this manual. Turn
idle screw (A) clockwise to increase
idle speed; counterclockwise to
decrease idle speed.
When carburetor adjustment is completed, the cutting
attachment should not move at idle, otherwise serious personal
injury may result.
Lubrication
Level 1.
Parts Required:
1.
Remove shield.
2.
Loosen bearing housing locating screw (A), at the top of the housing,
loosen mounting screw (B) and remove gear case from drive housing.
3.
Pull the flexible drive shaft (C)
from the drive housing, wipe
clean and apply 15 ml (0.5 oz.)
of grease.
4.
Slide the flexible drive shaft
back in the drive housing being
careful not to get dirt on the
flexible drive shaft.
5.
Install the bearing housing and
shield.
X7732274600
© 10/2017 ECHO Inc.
Lithium Based Grease.
MAINTENANCE
A
B
A
C
A
33
Advertisement
Table of Contents
