Advertisement
3. Pull up and remove the caster covers (2 loca-
tions).
Caster covers
4. Holding the lower adjusting bolt of the casters (4
places) in position, loosen the upper locking
bolts.
Then, turn the lower adjusting bolts to adjust the
height.
[Two in the rear]
If the positioning pin is higher
:Turn the bolt clockwise.
If the positioning pin is lower
:Turn the bolt counterclockwise.
[Two at the front]
If fixing bracket A is higher
:Turn the bolt clockwise.
If fixing bracket A is lower
:Turn the bolt counterclockwise.
• To adjust the height of the surface A of the Relay
Unit and surface B of the Finisher:
[Two each in front and rear]
If the surface A of the Relay Unit is higher
:Turn the bolt clockwise.
If the surface A of the Relay Unit is lower
:Turn the bolt counterclockwise.
Upper locking bolts
Lower adjusting
bolts
5. Press the Finisher against the main body and
check that clearance between the two is equal at
points a and b.
Note:
If the clearance at a is not equal that at b, readjust
with the casters.
4521IXC008DA
6. After the adjustment has been made, tighten the
upper locking bolts of the casters (4 places),
while holding the lower adjusting bolts in position.
Lower adjusting bolt
7. Mount using the reverse of the procedures used
to remove this described in steps 2 and 3.
8. Install the tray and protective guide that come
with the Finisher at the locations shown.
➀
➁
4521IXC009DA
E-4
a
b
Upper locking bolt
➀
➁
4521IXC022DA
4521IXC010DA
4521IXC011DA
Advertisement
