Panamorph CDR-S4 Installation Manual

CLEANING. Small amounts of dust and wipe marks are very
noticeable on lens surfaces with a high brightness projection beam but
typically will not impact the image as much as damage from excessive
cleaning in pursuit of a "perfect" optical surface. Occasionally blowing
off the lens surfaces with clean air is the best way to maintain long
term performance. If there is any excessive residue or build-up then it
is recommended that you clean the optics with professional lens
cleaning supplies such as from a camera store while the lens is in front
of the lit beam of the projector. This will allow you to quickly see if the
cleaning process is causing any damage.
LIMITED WARRANTY. Panamorph, Inc. warrants this product against
any change in performance or functionality for a period of twenty-four
months from our ship date. During this period, a unit may be repaired
or replaced, at the discretion of Panamorph, Inc., by returning it in its
original packaging with a copy of your receipt. This warranty does not
cover damage resultant from lack of prudent care, accident or misuse
(including use with other products in ways not intended); any cosmetic
damage not reported within 15 days of purchase; or any performance
change caused by the environment in which it is used. All damages are
limited to the cost of the product. This warranty is not transferable.
CDR-S4 Installation Guide Version 1.0
We bring cinema home
CDR-S4
Direct Attach Cinema Format Conversion Lens
INSTALLATION GUIDE
(Phillips #2 screwdriver required)
For use only with Sony VPL-XW6000ES
and VPL-XW7000ES

IMPORTANT THEATER GUIDANCE

1. Projection screen should be
minimum 2.0" screen border.
2. Projector lens center should be between -4 and +18 inches from
the top edge of the screen surface (about +3 to +5 inches is ideal)
and horizontally centered on the screen +/- 3 inches.
3. Throw ratio (projector throw distance divided by screen surface
width) should be at least 1.45:1.
4. Longer throw distances are encouraged to reduce edge
distortion. About 1.5" of screen border is needed to mask the edge at
a 1.45:1 throw ratio. About 1.0"
ratio distortion is very difficult to see in any content.
Patent Pending
®
projectors
flat , in the 2.4:1 aspect ratio and with a
is needed at 1.6:1. At a 2.0:1 throw