Attach The Cables - IBM Deskstar 25GP Installation And Reference Manual

• Leave the IBM Deskstar jumpers as set. The jumpers are factory set to Master, 16
heads.
• Set the jumpers on the existing drive for Slave. Refer to the existing drive label or
manual for jumper settings. You may need to remove the existing drive to change the
jumpers.
Note: The IBM Deskstar has an option jumper block located next to the interface connector.
Setting these jumpers allows you to use the different options of the hard disk drive. See the
"Jumpers" section of the Appendix for jumper setting descriptions.

Attach the cables

Note: With some system chassis, it may be more convenient to attach the cable after the drive is
mounted. The order of the following steps may change depending upon your system.
28