IBM Deskstar 25GP Installation And Reference Manual page 43

• The message "Remove disk from floppy drive" is displayed. Remove the IBM
DriveGuide diskette and click "OK". Turn off your computer.
• Remove the Slave drive from the system. Replace the system cover.
• Access your BIOS setup. Set the Drive Type setting for Primary Slave to "None" or
"Not Installed". Save the settings, exit, and reboot the system. The installation is
now complete. If EZ-BIOS was installed and you are rebooting to a diskette, see the
following important note.
IMPORTANT: If EZ-BIOS was installed during IBM DriveGuide installation, you must allow EZ-
BIOS to load in memory prior to booting to a floppy. If you do not perform the floppy boot process
below your drive's capacity and partitions will be unavailable.
Boot your system to the hard drive to load EZ-BIOS in memory. EZ-BIOS displays this message:
EZ-BIOS: Initializing...
EZ-BIOS: Hold the CTRL key down for Status Screen or to boot
from floppy...
Press the CTRL key. A status screen is displayed.
Insert the boot diskette and press A to boot from a floppy.
36