Hilti NURON TE 2000-22 Manual page 30

Trouble or fault
The battery does not engage
with an audible click.
The battery runs down more
quickly than usual.
Product does not start.
No hammering action.
Product or battery gets very
hot.
Product cuts out while in op-
eration or does not start
11 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
12 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
13 Further information
For more information on operation,
qr.hilti.com/manual/?id=2301751&id=2301753
This link is also to be found at the end of the documentation, in the form of a QR code.
24 English
Possible cause
Retaining lug on battery or tool
interface dirty.
Battery state of health is not opti-
mal.
Only one charged battery inserted.
The product is too cold.
Electrical fault.
Product/batteries too hot or batter-
ies too cold.
technology, environment and recycling,
Action to be taken
▶ Clean the retaining lugs and
re-insert the batteries.
▶ Call up the battery's state of
health. → page 19
▶ Insert the second charged
battery.
▶ Bring the product into contact
with the working surface, switch
it on and allow it to idle. If
necessary, repeat the procedure
until the hammering mechanism
begins to operate.
▶ Immediately switch off the prod-
uct. Remove the batteries and
keep them under observation.
Allow them to cool down. Con-
tact Hilti Service.
▶ Switch off; allow the
tool/batteries to cool down.
▶ Batteries too cold. Bring the
batteries to the recommended
working temperature.
follow this link:
2301751
*2301751*