External Network Interface; Manually Booting The System; Troubleshooting The Installation - Cisco XR 12404 Installation Manual

External Network Interface

Step 4

External Network Interface

Note

Manually Booting the System

Cisco XR 12404 Router Installation Guide
3-33
On the console terminal, verify that the console displays the system banner and
that the system and all interfaces initialize successfully.
If the router does not power on, or if any interfaces do not initialize properly, see
Chapter 4, "Troubleshooting the
the problem, contact your Cisco service representative for assistance.
After configuration, the RP and line cards can communicate with external
networks.
You do not need to configure the network interfaces immediately, but you cannot
connect to a network until you configure the interfaces for operation in your
networking environment.
The interface-specific LEDs on the line cards go on when the line card interfaces
are configured.
To verify correct operation of each line card interface, complete the first-time
setup procedures and configuration, then check the status of the interfaces against
the LED descriptions in the configuration notes for each line card.
If the system does not complete each of the boot process steps, go to

"Troubleshooting the Installation."

If your router does not find a valid system configuration image, or if you interrupt
the boot sequence, the system might enter read-only memory (ROM) monitor
mode and display the ROM monitor prompt (rommon>). From ROM monitor
mode, you have access to a number of commands to locate and boot a valid system
image.
Chapter 3
Installation,". If you are still unable to resolve
Installing the Router
"Chapter 4,
OL-13830-02