Removing And Replacing A Consolidated Switch Fabric Card - Cisco XR 12404 Installation Manual

Chapter 5 Maintaining the Router
Figure 5-23
Slide the CSF half-way out of the slot, then stop.
Step 4
Step 5 Touching only the metal card carrier, use your free hand to support the bottom of
the CSF and slide the card completely out of the chassis.
•
•
Set both edges of the CSF carrier into the card slot carrier alignment grooves on
Step 6
either side of the CSF slot and slide the card halfway into the chassis.
Pivot the ejector levers outward away from the faceplate.
Step 7
Slide the card into the CSF slot until the ejector levers make contact with the front
Step 8
of the card cage, then stop.
Pivot the ejector levers toward the faceplate until the connector properly seats in
Step 9
the backplane.
Tighten the two captive screws.
Step 10
Caution
Power on the router.
Step 11
OL-13830-02
Installing a CSF Card (with PRP-3 installed)
CLE AN CLAS S 1 LASE
R PROD UCT
CONNE CTOR LASER PROD
WITH ALCOHOL UKT DER KLASS
WIPES PROD UIT LASER E 1
CONNEC BEFORE
TING DE CLASS E
1
PRODU CTO LASER
TX
DE CLASS E 1
0
1
RX
2
3
ACTIVE
CARRIE R
RX PKT
ETH 0
ETH 1
BITS 0
BITS 1
AUX CONS
MBU S
ALARM FABRI
C
FAIL
ENAB LE
CO NS OL
IDA TE D
SW ITC
H FA BR
IC
Always place the CSF directly into an antistatic bag or other ESD-preventive
container.
If you plan to return the defective CSF to the factory, repackage it in the
shipping container you received with the replacement card.
Do not overtighten the captive screws; over tightening can strip the
threads on the screw or in the insert in the CSF faceplate.

Removing and Replacing a Consolidated Switch Fabric Card

40C 48/ PO
S-S R-S C
RESE T
OLE
PER FOR
MAN CE RP3
Cisco XR 12404 Router Installation Guide
5-37