Adjusting The Projection Position; Adjusting The Zoom; Adjusting The Picture Position - Hitachi CP-A100 User Manual – Operating Manual

Operating

Adjusting the projection position

This projector has four elevator feet in the bottom. Use them to adjust the
projection position.
Elevator feet
CAUTION
lengthened exceeding the limit may come off from the projector, and result in an injury.
►Tilt the projector with these elevating feet only.
►Do not tilt the projector over 5 degrees, when it is suspended from a ceiling or
somewhere.

Adjusting the zoom

Press the D-ZOOM + or D-ZOOM – button on the remote
control to display D-ZOOM dialog on screen.
Use the D-ZOOM + and D-ZOOM – buttons to adjust the
picture size.
To fi nish the operation, do not touch these buttons for a few
seconds until the dialog is disappeared.
● If you want to expand a part of the image, use the magnify
function (22).

Adjusting the picture position

Press the POSITION button on the remote control while no
menu is on screen, to display the D-SHIFT dialog on screen.
Use the ▲, ▼, ◄ and ► buttons to adjust the picture position.
Press the POSITION button again to fi nish this operation.
● This is a function to shift the position of the shrunken picture
by the zoom function.
● The function is not available, if any menu is displayed on
screen.
● The function is not available, if the D-ZOOM is adjusted to
100 (full screen) on its dialog.
0
►Do not lengthen the elevator feet to 43 mm or more. The foot
max. 43 mm
VIDEO COMPUTER SEARCH
ASPECT AUTO BLANK
D-ZOOM + button
MAGNIFY
HOME PAGE UP VOLUME
ON
END PAGE DOWN MUTE
OFF
FREEZE MY BUTTON KEYSTONE
1 2
FOCUS D-ZOOM
- + - +
POSITION MENU
ENTER
ESC RESET
D-ZOOM – button
VIDEO COMPUTER SEARCH
ASPECT AUTO BLANK
MAGNIFY
HOME PAGE UP VOLUME
ON
END PAGE DOWN MUTE
OFF
FREEZE MY BUTTON KEYSTONE
1 2
FOCUS D-ZOOM
- + - +
POSITION MENU
ENTER
ESC RESET
POSITION button