Setup Menu - Hitachi CP-A100 User Manual – Operating Manual

SETUP Menu

SETUP Menu
From the SETUP Menu, items shown in the table below
can be performed.
Select an item using the ▲/▼ cursor buttons, and press
the ► cursor button or the ENTER button to execute the
item. Then perform it according to the following table.
Item
D-ZOOM
D-SHIFT V
D-SHIFT H
KEYSTONE
WHISPER
MIRROR
VOLUME
(continued on next page)
36
Using the ▲/▼ buttons adjusts the zoom.
Large ó Small
Using the ▲/▼ buttons adjusts the vertical picture position.
Up ó Down
• The function is not available, if the D-ZOOM is adjusted to 100 (full
screen) on its dialog.
Using the ▲/▼ buttons adjusts the horizontal picture position.
Right ó Left
• The function is not available, if the D-ZOOM is adjusted to 100 (full
screen) on its dialog.
Using the ▲/▼ buttons corrects the vertical keystone distortion.
Shrink the top of the image ó Shrink the bottom of the image
• The adjustable range of this function will vary with the type of input
signal. For some input, this function may not work well.
• This function will be unavailable when the Transition Detector is
on (51).
Using the ▲/▼ buttons turns off/on the whisper mode.
NORMAL ó WHISPER
• When WHISPER is selected, acoustic noise and screen brightness
are reduced.
Using the ▲/▼ buttons switches the mode for mirror status.
NORMAL ó H:INVERT ó V:INVERT ó H&V:INVERT
If the Transition Detector is TURN ON and MIRROR status is
changed, Transition Detector Alarm (51) will be displayed when
projector is restarted after the power switch is turned off.
Using the ▲/▼ buttons adjusts the volume.
High ó Low
Description