Blank Search - JVC GR-D70 Instructions Manual

6 7
5 8
4
Speaker
NOTES:
● If Stop mode continues for 5 minutes when power is
supplied from a battery, the camcorder shuts off
automatically. To turn on again, set the Power Switch
to "OFF (CHARGE)", then to "PLAY".
● The playback picture can be viewed in the LCD monitor,
viewfinder or on a connected TV (
● You can also view the playback picture on the LCD
monitor with it flipped over and pushed against the
camera body.
● LCD monitor/viewfinder indications:
When power is supplied from a battery: the "
pack remaining power indicator is displayed.
When power is supplied from an AC outlet: "
not appear.
● When a cable is connected to the AV connector, the
sound is not heard from the speaker.
● If still playback continues for more than about 3 minutes,
the camcorder's Stop mode is automatically engaged.
● When 4/6
7
is pressed to engage still playback, the
image may not pause immediately while the camcorder
stabilises the still image.
%
Helps you find where you should start recording in the
middle of a tape to avoid time code interruption
(
1
2
then set the Power Switch
down the Lock Button
3
• "BLANK SEARCH"
automatically starts reverse or forward shuttle search,
u then stops at the spot which is about
3 seconds of tape before the beginning of the
detected blank portion.
To cancel Blank Search midway . . .
..... press 5
NOTES:
● In step 3, if the current position is at a blank portion the
u
● Blank Search does not work if "HEAD CLEANING
pg. 16).
● If the beginning or end of the tape is reached during
● A blank portion which is shorter than 5 seconds of tape
" battery
● The detected blank portion may be located between
" does

Blank Search

pg. 14).
Load a tape ( pg. 9).
Set the VIDEO/MEMORY Switch
y
located on the switch.
Press BLANK SEARCH
Q
appears and the camcorder
5
.
camcorder searches in the reverse direction, and if the
current position is at a recorded portion the camcorder
searches in the forward direction.
REQUIRED. USE CLEANING CASSETTE" has appeared
with the tape.
Blank Search, the camcorder stops automatically.
may not be detected.
recorded scenes. Before you start recording, make sure
there is no recorded scene after the blank portion.
y
u
4
to "VIDEO",
u
to "PLAY" while pressing
*
.
*
TAPE PLAYBACK
EN
15