Honeywell Dolphin 99EXL0 I Series User Manual page 168

Tools Required
• Drill
• 7/8 in. Drill Bit (for hollow wall installations) or
1/4 in. Drill Bit (for wood stud installation)
• Phillips Screw Driver
Hollow Wall Installation
1. Drill four pilot holes in the wall using a 7/8 in. drill bit.
6.5 in.
[16.5 cm]
2. Slide the bolt through the wall bracket, and thread the toggle nut onto
the bolt.
3. Press the ends of the toggle nut together, and insert the bolt/nut into the
pilot hole until the nut clears inside wall surface. The toggle nut should
spring open preventing the screw from being removed.
4. Repeat steps 2 and 3 for each of the remaining mounting holes.
5. Tighten all four bolts to secure the bracket to the wall.
6. Once the bracket is installed, secure the base to the wall bracket, see
Securing the Base to the Wall Bracket
Wood Stud Installation
1. Drill four pilot holes in the wall/wood stud using the 1/4 in. drill bit.
2. Secure the bracket to the wall using the four Hex Head Lag Screws provided.
3. Once the bracket is installed, secure the base to the wall bracket, see
Bracket for detailed instructions.
15 - 6
13.78 in.
[ 35 cm ]
Wall Mount Holes
for detailed instructions.
Wall Mount Bracket
Bracket
Bracket
Securing the Base to the Wall
Toggle Nut
Bolt
Wall
Wall
Open
Toggle Nut