Table of Contents
Advertisement
AddressInitial
Type
84
1 EEP_RuClipDelayBeforeReq
85
1 EEP_RuRcvDigitBeforeReq Receive Digit Before REQ
86
1 EEP_PseudoBellLength Pseudo Bell Length
87
1
EEP_PseudoBellInterdigitTimeout
88
1 E EP_PseudoBellEndTimeout
89
1
EEP_RuClipReqLev RCID REQ signal Level
272
2
EEP_RuClipOnOff
273
2
EEP_RuClipRingNumBeforeSequence
274
2 EEP_RuClipDisplayDigit N umber Of digits to be displayed
28. EEPROM LAYOUT (CORDLESS HANDSET)
28.1. Scope
The purpose of this section is to describe "layout of the EEPROM (IC10) KX-TCA151 Cordless
Handset".
The EEPROM contains hardware, software, and user specific parameters. Some parameters are
set during production of the cordless handset e.g. crystal oscillator adjustment at 0057, some
are set by the user when configuring the cordless handset e.g. ringer volume at 00A1, and some
during normal use of the phone e.g. redial memory at 1EF6..1F77.
28.2. Introduction
The handset uses a 64k bit serial EEPROM (IC10) for storing volatile parameters. All parameters
are set up before the cordless handset the factory. Some of these are vital for the operation of
the hardware so a set of default parameters is programmed before the actual hardware fine-
tuning can be initiated. This document lists all default settings with a short description.
This document lists all default parameters with a short description.
In the tables below values in a range that are similar are not repeated; i.e. Address 00 to 01
contains the value 00 simply means that the value 00 is repeated in all addresses in the range.
Name
Delay before Send REQ signal
Unit : 10ms, Default : 200ms
Default : 2digit
Unit : 10ms, Default : 800ms
Pseudo Bell Interdigit Timeout
Unit : 100ms, Default : 3200ms
Pseudo Bell End Timeout
Unit : 1s, Default : 30s
Default : -4.3dBm
Russian CLIP On/Off
Number Of Rings Patterns Before Start
Sequence
Default : 1
Default:7 digits
Description
98
Default value
0x14
0x02
0x50
0x20
0x1E
0x00, 0x19
0x01
0x01
0x07
Advertisement
Table of Contents
