Table of Contents
Advertisement
Tip Temperature of 700°F ± 20°F (370°C ± 10°C)
Note: We recommend a 30 to 40 Watt soldering iron. An expert
may be able to use a 60 to 80 Watt iron where someone with less
experience could overheat and damage the PCB foil.
- Flux
Recommended Flux: Specific Gravity
Type
RMA (lower residue, non-cleaning type)
Note: See
ABOUT LEAD FREE SOLDER (PbF: Pb free)
29.2. Procedure
1. Tack the flat pack IC to the PCB by temporarily soldering two
diagonally opposite pins in the correct positions on the PCB.
Be certain each pin is located over the correct pad on the PCB.
2. Apply flux to all of the pins on the IC.
3. Being careful to not unsolder the tack points, slide the soldering
iron along the tips of the pins while feeding enough solder to the
tip so that it flows under the pins as they are heated.
0.82.
().
103
Advertisement
Table of Contents
