Cisco uBR10-SRP-OC12SML Instructions Manual page 16

About Removing and Replacing a Cisco uBR10-SRP-OC12SML DPT WAN Line Card
Removing the Line Card from the Chassis
Attach an ESD preventative ground strap to your wrist and to a bare metal, unpainted surface on the
Tip
chassis or frame.
Face the back of the Cisco uBR10012 chassis. If necessary, clear enough interface and power cables to
Step 1
allow sufficient space to work.
If you are replacing the Cisco uBR10-SRP- OC12SML DPT WAN line card, disconnect the cables from
Step 2
the line card being replaced.
If you are installing a new line card, remove the blank slot cover and discard it; then, go to
the Cisco uBR10-SRP-OC12SML DPT WAN Line Card, page
Figure 7
Cisco uBR10-SRP-OC12SML DPT WAN Line Card
16
Location of Cisco uBR10-SRP- OC12SML DPT WAN Line Card Captive Screws
CI SC O
10 00 0 CI SC O
10 00 0
Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router
19.
Captive Screws
CI SC O
10 00 0 CI SC
10 0
Uplink line card slot 4/0
Uplink line card slot 2/0
Captive Screws
Replacing
78-13602-01