Advertisement
2. Some grinders need preparation for [b] Adapting Unit.
[b]
(Factory default)
(OLD type) L3410FR, L3410VR type
HD28AG-125, AGV17-125,
AG16-125, AG8-125, AG9-125 type
#10 x 5pcs.
#15 x 2pcs.
・Take Clumping system off from [b] Adapting Unit.
3. Switch the Lower Brackets position when the gearcase size D of the angle grinder is larger than 47mm.
[for D<47
(Factory default)
4. Place [b] Adapting Unit on gearcase of the
grinder.
-2-
Refer to the
Installation Guide.
Upper Bracket
Lower Bracket
[b]
D<47
grinder]
mm
[e] Offset Plate or [ f ] Milwaukee Plate must be set on gearcase for some grinders.
[b]
Gearcase
[d]
[b]
(1) Change the Upper Bracket direction by operating [d] Wrench.
(2) Add [n] Washer into the Lower Brackets. (2pcs.)
L1506VR, L9-11 125, LE9-11 125, L12-11 125, L13-10 125-EC, LE14-7 125 INOX, L15-11 125,
LE15-11 125, L3406VRG, LB17-11 125 type
[d]
[b]
(1) Change the Upper Bracket direction by operating [d] Wrench.
(2) Detach the Bracket Cover and attach [p] Hook to the Lower Brackets. (2pcs.)
M18FHSAG125, AGV13-125XSPDEB, M18FSAGV125, AGV15-125,
AGV13-125, AG13-125XSPD, AGV12-125 type
[b]
mm
[e]
9558 / 9565 type
D28134 / DCG412N type
L1400 125 type
HD18 type
, GA5050R type
・Take Support Bar off from [b] Adapting Unit.
[for D>47
grinder]
mm
L1400 125 type.
#7
[n]
Bracket
Cover
#7
[p]
#10
Support
Bar
#15
D>47
mm
[ f ]
M18FHSAG125, AGV13-
125XSPDEB, M18FSAGV125,
AGV15-125, AGV13-125,
AG13-125XSPD, AGV12-125
type
Advertisement
