Advertisement
2
ATW Wireless System
When the indoor unit is operating, the room temperature display shows the
actual room temperature (18°C) below and the set temperature (20°C)
above as shown in the figure to the right. The measurable temperature
range is from 0°C to 40°C.
If the measured room temperature is out of 0°C to 40°C range,
the room temperature display blinks.
When the wireless remote controller is installed on a bracket, room temperature might not be accurate being affect-
ed by the wall temperature.
Perform a test run and place the remote controller where the room temperature can be correctly detected.
6.6. Automatic Zone No. Display (Mode No. 5)
Set the mode no. to "5".
When the automatic zone no. display is active, a zone number as-
signed to the remote controller is displayed for 3 seconds after tem-
perature setting.
Press
or
button to select between "
button to save setting.
Inactive
:"
".
Active
:The zone no. (
is shown.
D-22
" and
or
, and press
or
) assigned to the remote controller
Optional parts
<Inactive>
<Active>
Advertisement
