Advertisement
2
ATW Wireless System
5. Pairing process
● If the wireless remote controller is not paired, the indoor unit cannot be operated using the remote controller.
● Before using the wireless remote controllers, always ensure to go through a pairing process.
● Pairing is NOT possible unless the ecodan system is off. When the ecodan system is ON, be sure to turn it off be-
fore starting the pairing process.
● The wireless receiver is also needed for pairing, so please make sure to operate the wireless remote controller
near the wireless receiver.
Hold down
button on the wireless receiver for 3 seconds or more
until orange
LED blinks.
The pairing mode is cancelled by pressing
Hold down
,
and
When
button is pressed in the middle of setting, the screen
returns to the previous indication.
When
appears on the display, do not perform pairing. The
power may be turned off in the middle of pairing, which may
lose the pairing information.
Press
or
button to select a pairing address, and press
button to set the address.
"
" (no setting) is displayed initially. Choose a number from 1 to 8.
After pressing
button, the wireless remote controller starts
communication with the wireless receiver.
When using multiple wireless remote controllers in one eco-
dan system, be sure to set different address for each remote
controller.
When the pairing process has been successfully performed, "
is shown on the remote controller and green
lights on the wireless receiver.
button.
buttons simultaneously for at
Mode No.
LED steadily
Press
or
button to set the mode number to "1" and
press
button.
<Pairing is successful>
"
Blinking (orange)
Optional parts
Blinking (orange)
Lighting (green)
D-19
Advertisement
