Advertisement
2
ATW Wireless System
6.1. Viewing Address Number (Mode No. 0)
Set the mode no. to "0".
The display to the right shows that the address is set to "2".
6.2. Pairing (Mode No. 1)
For details, refer to "6. Pairing process".
6.3. Selecting the Temperature Unit (Mode No. 2)
Set the mode no. to "2".
The temperature reading can be selected between Celsius (°C) or Fahr-
enheit (°F).
Press
or
button to select °C or °F and press
the selection.
6.4. Communication Test (Mode No. 3)
Set the mode no. to "3".
Communication test is performed between the wireless remote control-
ler and the wireless receiver.
When the display shows "
tween the remote controller and the receiver is established. If "
shown, the wireless remote controller is not communicating with the
wireless receiver.
Do not leave the wireless remote controller in a location where the
communication test results in "
Before conducting the communication test, ensure that the wireless remote controller goes through a pairing process.
6.5. Displaying or Hiding Room Temperature (Mode No. 4)
Set the mode no. to "4".
Select either displaying or hiding the room temperature.
Press
or
button to select displaying or hiding the room tempera-
ture, and press
button to save the setting.
Hiding
:"
".
Displaying
:Actual room temperature is displayed
button to confirm
", this indicates that the communication be-
".
" is
<When the actual room temperature is NOT displayed >
<When the actual room temperature is displayed >
Optional parts
D-21
Advertisement
