Table of Contents
Advertisement
To program the engagement sensor pullup:
When the system is engaged, there will need to be some sort of signal
to indicate this engagement. If the signal is just a switch connected to
ground, with no light or any other connection to the switch, the pullup will
need to be turned on in order to detect the switch. If the signal is a switch
connected to 12 volts, or a voltage on a light bulb, then the pullup is not
needed.
1. Hold down the SELECT button to enter the programming mode.
Once the top display shows "
the programming mode, release the button.
2. Press the SELECT button again until the top display shows "
3. Press the SET button to change the pullup between on "
OFF
"
".
4. Press the SELECT button to scroll through the remaining programming
option. After the last option, the display will show "
button is held down. When the button is released, the system will
return to normal operation within a second. If at any time no button
is pressed for 5 minutes, the system will return to normal operation. If
you wish to remain in the programming mode, press the SET button
while still holding down the SELECT button when the display shows
". This returns you to the first programming menu item.
donE
"
To program the engagement sensor polarity:
When the system is engaged, there will need to be some sort of signal to
indicate this engagement. If the signal is a ground to indicate engagement,
then the polarity will need to be set to ground. If the signal is 12 volts to
indicate engagement, then the polarity will need to be set to power.
1. Hold down the SELECT button to enter the programming mode.
Once the top display shows "
the programming mode, release the button.
2. Press the SELECT button again until the top display shows "
3. Press the SET button to change the polarity between ground "
and 12V power "
4. On the right side of the bottom display, the engagement sensor status
is shown. As the polarity is changed, this will update immediately to
confirm that the correct setting is being used.
5. Press the SELECT button, the display will show "
button is held down. When the button is released, the system will
return to normal operation within a second. If at any time no button
is pressed for 5 minutes, the system will return to normal operation. If
you wish to remain in the programming mode, press the SET button
while still holding down the SELECT button when the display shows
". This returns you to the first programming menu item.
donE
"
672-H Manual
HnDE
HndE
12V
".
" to show that you have entered
" to show that you have entered
PToP
.
" and off
On
donE
" while the
PtoE
".
6nD
donE
" while the
Page 21
"
Advertisement
Table of Contents
