Table of Contents
Advertisement
3. Press the SET button to change the mode between steady "
and oscillating ""
4. Press the SELECT button repeatedly to scroll through the remaining
programming options. After the last option, the display will show
donE
"
" while the button is held down. When the button is released,
the system will return to normal operation within a second. If at any
time no button is pressed for 5 minutes, the system will return to
normal operation. If you wish to remain in the programming mode,
press the SET button while still holding down the SELECT button when
the display shows "
menu item.
To program the warning horn to turn off or stay on after the warning
time has expired:
The horn warning can be set to turn off after the warning time has expired,
or to stay on and continue indefinitely.
1. Hold down the SELECT button to enter the programming mode.
Once the top display shows "
the programming mode, release the button.
2. Press the SELECT button again until the top display shows "
and the bottom display shows "
3. Press the SET button to change the mode between staying on "
and turning off "
4. Press the SELECT button repeatedly to scroll through the remaining
programming options. After the last option, the display will show
donE
"
" while the button is held down. When the button is released,
the system will return to normal operation within a second. If at any
time no button is pressed for 5 minutes, the system will return to
normal operation. If you wish to remain in the programming mode,
press the SET button while still holding down the SELECT button when
the display shows "
menu item.
To program the final alarm:
When ground is lost and the warning horn has timed out, the final alarm
will be activated. This output can be programmed to go to an open or
closed circuit when activated.
1. Hold down the SELECT button to enter the programming mode.
Once the top display shows "
the programming mode, release the button.
2. Press the SELECT button again until the top display shows "
3. Press the SET button to change the mode between open circuit
OPEn
"
" and closed circuit "
672-H Manual
OSCL
".
". This returns you to the first programming
donE
HndE
OFF
".
". This returns you to the first programming
donE
HndE
CLOS
" to show that you have entered
On
Off
" or "
".
" to show that you have entered
".
StEd
"
Horn
"
On
"
FinL
".
Page 19
Advertisement
Table of Contents
