Wilfa UNIFORM Instruction Manual page 12

TROUBLESHOOTING
EN
Problem
Coffee grinder
does not start
Coffee grinder
clogs
Coffee grinder
grinds to
coarse even at
finest settings
It's hard to
adjust to finer
settings
INSTRUCTION MANUAL · UNIFORM
Possible causes
Power cord is not plugged in
Bean hopper is not in correct
position
Using setting 1-4 might clog
the burrs.
Bean hopper not fully rotated
in place.
Grinded beans might stuck
between the burrs.
10
Solution
Plug into power socket
Rotate the bean hopper
properly into locked position.
Set grinder to 25 and
gradually adjust back to
the wanted setting while
the motor is running with
beans in the hopper. This
will remove clogging of the
burrs.
Depending on type of beans,
wear and factory calibration
the machine might clog at
the finest settings.
To find the finest setting
before clogging: Lower
setting gradually until the
burrs clog. If it clogs at
setting 3 then setting 4
should be considered as
finest setting.
If the beans are grinded
coarse even on the finer
settings the head might not
be in place. Try to rotate
the bean hopper one more
revolution.
Let the motor run while
adjusting to a finer setting.