Advertisement
How to Install a Single QC-S300/QC-S30 Collator
2
.
Attach the bin shelves, beginning from the
bottom, by following the steps below.
(1) On the drive side of each bin shelf, an arm fits
under a pin inside the machine. A pin on the bin
shelf fits into a notch in the frame of the machine.
(2) On the near side of the machine, fit the arm under
the pin inside the machine. A pin on the bin shelf
fits into an U-shaped output on the machine frame.
(3) Swing the bin shelf down to lock it in position.
(4) Install all of the other bin shelves by repeating the
steps 1 through 3.
3
.
Plug the power cord into the QC-S300/
QC-S30.
4
.
Plug the power cord into an outlet.
Important
• Plug the power cord into a properly-grounded outlet.
• If you must use an ungrounded outlet, be sure to
ground the machine separately. A poor ground can
cause problems for the machine due to by static
electricity, lightning strikes, or current leakage.
WARNING
• Do not ground the machine to a gas pipe.
Pin
U-shaped Cutout
After the installation is complete, set the AC
power supply frequency. See the instructions
for "QC-S300/QC-S30 Frequency Setting."
This is shipped with the machine.
Arm
21101
10101A1
Arm
Pin
21101
10101B1
BIn Shelf
21101
10101C1
Power Cord
21101
10101D1
3
Advertisement
