Advertisement
Installing a QC-S300F/QC-S30F Extension Module
WARNING
• Do not install the QC-S300F/QC-S30 on an
unstable floor. The machine may fall over.
The machine frame may be twisted, and this
could affect the machine performance.
• The QC-S300F/QC-S30 weighs about 73Kg
(160.6 lb). This machine must be installed
by at least two people.
1.
Unpack the collator.
• This machine must be moved by at least two people.
• Check the accessories shipped with the machine.
2.
Install each QC-S300F/QC-S30F on the
table by following the steps below.
If optional MT-100 table is used, follow
the steps (1) through (3) described below.
(1) Attach the base plate at the bottom of the QC-
S300F/QC-S30F using two mounting screws.
Important
• Attach the base plate in the correct direction referring
to the figure to the right. (Two left feet enter the holes
on the base plate.)
(2) Place the QC-S300F/QC-S30F on the MT-100.
• Insert the projection on the base plate into the holes on
MT-100.
(3) Temporarily place the QC-S300F/QC-S30F 1 m
(40") to the left of the other QC-S300F/QC-S30F unit
as shown in the illustration (viewed from the front).
Important
• Be sure to push the bottom of the transport door side
of the QC-S300F/QC-S30F when moving the
machine. Do not push the bin side. This could cause
the QC-S300F/QC-S30F to fall over.
(4) Install four skirts.
CAUTION
• Be sure to turn off the power switch on the
QC-S300F/QC-S30F.
How to Install Multiple QC-S300F/QC-S30F Collators
Additional Collators: QC-S300F/QC-S30F
Optional Table: MT-100
* If you are installing QC-S300F/QC-S30F on any
table except the MT-100, choose a stable table
which can support at least 80 kg (176 lb).
Before installing the QC-S300F/QC-S30F,
complete the installation of the QC-S30 and set
the AC frequency for the AC power supply.
831 (32.8")
363 (14.3")
138 (5.4")
Height : 600mm (23.7")
To connct one more collator, extra 831mm (32.8") length is required.
Mounting
Screw
Left Feet
21101
20101K1
1,861(73.3")
1030 (40.5")
mm(inch)
960 (37.8")
241 (9.8")
196 (7.7")
21101
20102L1
Projection
Base Plate
21101
20101J1
MT-100
Skirt
21101
20101L1
5
Advertisement
