Table of Contents
Advertisement
Medema A/S
User guide 2433-2018-B
Place the two plates on each side of the nuts. Fix
them with double sided tape or a little glue.
Mount the batteries, hoist and tilt module, the seat and legrests
again. Check that all funcions are working ok.
To release the chair, use the electric release button that is
installed in the car in the operating area. If the car is turned off,
or if it just needs power, there will be a manual release lever as
well.
The docking station are
mounted in the car bottom.
It must be carried out by
an authorized workshop.
Move the chair over the
docking station, and it will
grab the locking plate. A
click sound mean it is in
place and secured.
44 of 96
The screws may be too
long and must then be
shortened.
If they get too long, they
can damage the batteries.
Important! Do not use
screws other than those
supplied by Dahl Engineer-
ing (Art.nr.502800, which
is quality 14.9, torx key
size 27). Standard counter-
sunk M8 screws will not be
strong enough in a crash.
The plates in the bottom
makes it possible to slide the
batterybox over the nuts.
Version 2.0.1/2022
Advertisement
Table of Contents
