medemagroup MC 1124 Child User Manual page 17

Medema A/S
User guide 2433-2018-B
the control system is changing between different states.
An example would be entering into Programming Mode.
(Only for service technicians)
If the External Profile Switch is activated during drive, or
actuator operation, this symbol will be displayed.
When Blue tooth Mode is entered the following screen
will be displayed.
If you operate the Joystick before or just after you switch
the control system on, the screen will flash the joystick
displaced screen.
You must release and centre the Joystick to resume nor-
mal operation. If you do not release the Joystick within
five seconds the wheelchair will not be able to move,
even if you release the Joystick and operate it again.
The screen will display a diagnostic screen at this time.
You can reset this condition by switching the control
system off and on again.
Displays the sections of the chair currently selected for
movement.
When Bluetooth Mode is entered the following screen
will be displayed.
This symbol will be displayed for a short time before the
R-net enters into a sleep state.
When the control system safety circuits have operated
and the control system has been prevented from moving
the wheelchair a diagnostics screen will be displayed.
This example show a warning of low battery voltage,
and a trip code in the top right corner.
17 of 96 Version 2.0.1/2022