medemagroup MC 1124 Child User Manual page 41

Medema A/S
User guide 2433-2018-B
Warning!
Do not move the vehicle:
• Whilst the wheelchair is being maneuvered into position in the
docking station
• If the wheelchair and user are not correctly secured.
• If the warning tone sounds and/or the red warning lamp (LED) in
the control panel flashes or is lit!
Always check if the lock plate is properly engaged in the dock-
ing station by trying to reverse the wheel chair out of the dock-
ing station before moving the vehicle. (It must not be possible
to reverse out of the docking station without pressing the red
release button in the control panel).
Release from the docking station
1. When the vehicle has been brought to a halt, remove the safety belt.
2. To unlock commence by driving the wheelchair forward to release pressure
on the lock pin.
3. Press the red release button in the control panel. The locking pin will be
triggered/ released for approx. 5 seconds, after which the locking pin is
automatically locked/activated again.
4. Move the wheelchair away from the docking station within this 5-second
period. Do not attempt to reverse out of the docking station until the red
LED on the control module, which indicates the unlock position, has
been illuminated.
Warning!
Attempting to reverse the wheelchair before the red LED has
been illuminated will result in blocking the docking stations lock-
ing mechanism, which makes it impossible to reverse. If this
happens repeat above unlocking procedure.
Manual release in case of electric failure
A manual emergency release is located at the front edge of the
docking station.
1. Move wheelchair forward to remove the pressure on the lock pin and push
the red release arm to one side and hold it there while the wheelchair
moves away.
2. A cable-activated manual operating lever can also be fitted (accessory). The
red release arm is also pushed to one side and should be held there
whilst the wheelchair moves away.
41 of 96 Version 2.0.1/2022