Table of Contents
Advertisement
Operating Conditions for the European Community
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any
repairs or alterations made by the user to this equipment, or equipment malfunctions may give the
telecommunications company cause to request the user to disconnect the equipment.
Users should ensure for your own protection that the electrical ground connections of the power utility,
telephone lines and internal metallic water pipe system, if present, are connected together. This
precaution may be particularly important in rural areas.
Users should not attempt to make such connections themselves, but should contact the appropriate
Caution
electric inspection authority, or electrician, as appropriate.
Operating Conditions for the European Community
The warnings and safety guidelines listed in the
to routers used in the European Community.
Operating Conditions for the United Kingdom
In addition to the warnings and safety guidelines listed in the
page
•
•
•
•
Declaration of Conformity
The Declaration of Conformity related to this product is located at the following URL:
http://www.cisco-compliance.com/compliance.asp
Regulatory Compliance and Safety Information for Cisco SB 100 Series Routers
22
24, the following warnings apply to routers used in the United Kingdom:
Interconnection directly, or by way of other apparatus, of ports marked:
"Safety Warning—See instructions for use"
with ports marked or not so marked may produce hazardous conditions on the network, and that
advice should be obtained from a competent engineer before such a connection is made.
The ports marked "Ethernet" and "Console" have a safety warning applied to them as follows:
"These ports do not provide isolation sufficient to satisfy the requirement of EN 41003; apparatus
connected to these ports should either have been approved to EN 41003 or have previously been
evaluated against B5E301 British Telecommunications plc (Post Office) Technical Guides 2 or 26
and given permission to attach; any that other usage will invalidate any approval given to this
apparatus."
Other usage will invalidate any approval given to this apparatus if as a result it ceases to comply with
EN 41003:1993.
This apparatus must be connected to a main socket outlet with a protective earth contact.
Connection of power supply: The router is intended for use when supplied with power from a supply
providing 100 to 250 VAC, 50 to 60 Hz up to 0.5A.
"Obtaining Documentation" section on page 24
"Obtaining Documentation" section on
apply
78-16777-01
Advertisement
Table of Contents
