Table of Contents
Advertisement
Installation Guide SMX-AUS
2. Panel mounting
Perform the following steps to mount the panel on the wall as per the surface mounting method:
Fig. 3: Dimensions (all dimensions in mm)
Remove the panel after marking and before drilling the hole to avoid any damage to the panel.
12
Fig. 4: Mounting the Panel
•
Hold the panel on to the wall at the position you want
to install it. Verify the space available for opening the
door of the panel and if the panel is accessible.
•
Unlock the panel door using the door key.
•
Mark the position of top center hole on the wall for
drilling.
•
Drill the hole and install the screws with
recommended size: M6 x 40 mm.
•
Mount the panel on top of the screws.
•
Use the spirit level indicator to adjust the panel to the
horizontal plane.
•
Mark the bottom two holes position on the wall for
drilling.
•
Drill the hole and install the screws with
recommended size: M6 x 40 mm.
•
Remove the required number of cable-entry
knockouts (refer to Fig. 5) from the panel.
•
Mount the panel with the 4 screws.
NS-MN-0030 / 11.2020
Advertisement
Table of Contents
