Removing The Power Cord - JVC SX-DW303 Service Manual

SX-DW303

Removing the power cord

Prior to performing the following procedures, remove
the rear panel.
Remove the two screw
1.
bracket a.
2. Pull out the bracket a toward you.
Remove the connection of the wire connector
3.
Removing the amplifier assembly board
Prior to performing the following procedures, remove
the rear panel and the power cord.
1. Remove the screw marked D that is fixing the
bracket b.
2. Remove the three screws marked E that are fixing
the bracket c.
3. Remove the wire connecter CN102 and CN503.
4. Remove the connection of the connector CN951 and
CN952.
5. Pull out the amplifier assembly board toward you.
Removing the power supply assembly
bord
Prior to performing the following procedures, remove
the rear panel and remove the power cord.
1. Remove the amplifier board assembly.
2. Remove the six screws marked F attaching the
power board assembly.
3. Pull out the power supply board assembly toward
you.
1-4
(See Fig.4, 5)
marked C attaching the
(See Fig.5, 6)
(See Fig.6 )
Fig.4
Bracket c
CN503
CN102
E
Bracket b
D
Fig.5
F
CN951
Fig.6
Power
cord
C
Bracket a
Amplifier
assembly
board
E
CN901
Power supply
assembly
board
F
CN952