Installation; Location - Hatco Glo-Ray GRHW-1SGD Series Installation & Operating Manual

INSTALLATION

Screw
Glo-Ray Merchandising Warmers are shipped with most
components pre-assembled. Care should be taken when
unpacking shipping carton to avoid damage to unit
and components enclosed.
1. Remove the unit from the carton.
2. Remove information packet. To prevent delay in
obtaining warranty coverage, fill out and mail in
the warranty card.
3. Remove all tape and packing materials.
4. Remove upper two screws from each side
of the unit. See Figure 3.
5. Install sign holder using original screws.
6. Tighten thumb screws holding personnel protectors
in place until snug. See Figure 3.
7. Slide each glass panel up into the upper channel then
down into the lower channel. See Figure 4.
NOTE: Side glass panels have a special "Low E"
coating applied to one side. The "Low E" coated side
must face inward and the word on the glass "out" must
face outward.
CAUTION
Do not lay unit on the side with the control panel
or damage to unit could occur.
CAUTION
Do not drag or slide the unit when moving
or installing. Carefully lift the unit to prevent
the rubber feet from tearing off.
Form No. GRHWSGDM-0902
Thumb Screws
Figure 3. Sign Holder Installation
Figure 4. Side Glass Installation
Unit is not weatherproof. For safe and proper
operation locate the unit indoors where the ambient
air temperature is constant and is a minimum
of 70°F (21°C).

LOCATION

For proper operation and maximum performance, locate
the Merchandising Warmer in an area where the ambient
air temperature is constant and is a minimum
of 70°F (21°C). Areas which are susceptible to active air
movements or currents should be avoided, i.e., near
exhaust fans or hoods and air conditioning ducts.
For safe and proper operation, the unit must be
located a reasonable distance from combustible walls
and materials. If safe distances are not maintained,
discoloration or combustion could occur.
4
Sign Holder
Personnel Protector
CAUTION
WARNING