Table of Contents
Advertisement
DEALER PRE-DELIVERY CHECKLIST
(DEALER'S RESPONSIBILITY)
Inspect the equipment thoroughly after assembly to
ensure it is set up properly before delivering it to the
customer.
The following checklists are a reminder of points to in-
spect. Check off each item as it is found satisfactory or
after proper adjustment is made.
Check that all safety decals are installed and in
good condition. Replace if damaged.
Check that shields and guards are proper-
ly installed and in good condition. Replace if
damaged.
Check all bolts to be sure they are properly
torqued.
Check wheel bolts for proper torque.
Check that all cotter pins and safety pins are
properly installed. Replace if damaged.
Check that blades have been properly installed.
Check and grease all lubrication points as identi-
fied in lubrication information on page 20.
Check the level of gearbox fluids before delivery.
Service, if required, as specified in the lubrica-
tion information on page 20.
DELIVERY CHECKLIST
(DEALER'S RESPONSIBILITY)
Show customer how to make adjustments and
select proper PTO speed.
Show customer how to make sure driveline is
properly installed and that spring-activated lock-
ing pin or collar slides freely and is seated in
groove on tractor PTO shaft.
Show customer how to determine the turning
limits of the CV PTO driveline.
MAN1337
( 05/03/22 )
DEALER CHECKLISTS
Show customer the safe, proper procedures to
be used when mounting, dismounting, and stor-
ing equipment.
Make customer aware of optional equipment
available so that customer can make proper
choices as required.
Instruct customer how to lubricate and explain
importance of lubrication.
Point out the safety decals. Explain their mean-
ing and the need to keep them in place and in
good condition. Emphasize the increased safety
hazards when instructions are not followed.
Explain to customer that when transporting the
cutter, the wing and center sections should be
raised and their respective transport bars in-
stalled and pinned in place.
Present Operator's Manual and request that cus-
tomer and all operators read it before operating
equipment. Point out the manual safety rules,
explain their meanings and emphasize the in-
creased safety hazards that exist when safety
rules are not followed.
Explain to customer the potential crushing haz-
ards of going underneath raised equipment.
Instruct that before going underneath to discon-
nect the driveline, securely block up all corners
with jack stands and to follow all instructions in
the BLOCKING METHOD, page 19 of the oper-
ator's manual. Explain that blocking up prevents
equipment dropping from hydraulic leak down,
hydraulic system failures or mechanical compo-
nent failures.
Point out all guards and shields. Explain their im-
portance and the safety hazards that exist when
not kept in place and in good condition.
Explain to customer that when towing on a public
road to comply with all state and local lighting/
marking laws and to use a safety tow chain.
Dealer Checklists 35
Advertisement
Table of Contents
