Britax E9L06 Quick Start Manual

Figure 1 shows Items needed for top tether hook
replacement.
Included in Kit:
• "DO NOT USE" label
• Replacement top tether hook
Attaching the Label
1. Place child restraint on a flat surface facing
away from you, Fig 2.
2. Locate the top tether hook on the rear of the
restraint, Fig. 3.
3. Place the "DO NOT USE" label included with
this kit over the top tether hook (lot number
KGRO1A) attached to your restraint.
a. Start by attaching the thin end of the label
to the hook tongue underneath the rivet on
the back of the top tether hook, Fig. 4.
b. Continue to wrap the label along the length
of the hook, pressing firmly to ensure
the adhesive covers the connection point
between the tongue and hook, Fig. 5.
c. The label should terminate beneath the
rivet on the front of the top tether hook,
Fig. 6.
Top Tether Hook Replacement
1. Loosen the top tether connector strap by
pressing the release button and pulling back
on the top tether connector strap to create
more slack, Fig. 7.
P age 3 o f 4
R 1: 10 .0 7
P 307 3 0 0
Top Tether Hook Replacement Instructions
For Britax
Model Nos. E9L06, E9W06, E906 manufactured May 23, 2006 – July 28, 2006
Back Side of
Rivet
Front Side of
Rivet
Marathon Child Restraint
®
"Do Not Use"
2
Connection Point
4
6
B r it a x C h i l d S a f t ey, I n c . , 1 3 5 0 1 S o u t h R i d g e D r i ve , C h a r l o t t e , N C 2 8 2 7 3
© 2 0 0 7 B r it ax C h i l d S a f t ey, I n c . A l l r i g h t s re s e r ve d .
Hook Lot No. KGR01A
Top
Tether
label
Hook
1
Top Tether Hook
3
5
Adjuster
Release
Button
7
R ec a l l Se r v i c e : 8 0 0 . 6 8 3 . 2 0 4 5
w w w. B r it ax U S A . co m