Maintenance; General; Cleaning; Display Light Bulb Replacement - Hatco GR2SDH-24 Installation And Operating Manual

MAINTENANCE

GENERAL

The Hatco Glo-Ray Designer Merchandising
Warmers are designed for maximum durability and
performance, with minimum maintenance.
WARNING
To avoid any injury, turn the power switch off at
the fuse disconnect switch/circuit breaker or
unplug the unit from the power source and allow
to cool completely before performing any
maintenance or cleaning.
WARNING
To avoid electrical shock or personal injury, do
not steam clean or use excessive water on the
unit.
WARNING
To avoid electrical shock, personal injury or
damage to the unit, DO NOT submerge in water.
Unit is not waterproof. Do not operate if it has
been submerged in water.
WARNING
To prevent electric shock, always unplug the unit
before performing cleaning or maintenance.

CLEANING

To preserve the bright finish of the Glo-Ray Designer
Merchandising Warmer, it is recommended that the
exterior and interior surfaces be wiped daily with a
damp cloth. Stubborn stains may be removed with a
good non-abrasive cleaner. Hard to reach areas
should be cleaned with a small brush and mild soap.
NOTICE
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit,
marring its appearance
susceptible to dirt accumulation.
Clean the glass sides using a common glass
cleaner.
NOTICE
Only soft cleaning cloths, mild soap and water
should be used to clean breath protector(s). Do
not use paper towel or glass cleaner. Breath
protector(s) are
polycarbonate and will scratch or crack if proper
care is not taken.
Form No. GR2SDM-0707
and making
made of shatterproof

DISPLAY LIGHT BULB REPLACEMENT

The display light is an incandescent light bulb which
illuminates the warming area. The bulb has a special
coating to guard
contamination in the event of breakage.
1. To replace a light bulb, disconnect the power
supply and wait until the unit has cooled.
2. Bulbs have a threaded base. Unscrew the light
bulb from the unit and replace it with a new
specially coated incandescent bulb.
NOTE: Hatco shatter-resistant light bulbs meet NSF
standards for food holding and display areas. For
120, 120/208 and 120/240 volt applications, use
Hatco part number 02.30.043.00. For 220, 240, 220-
230 and 230-240 volt, use Hatco part number
02.30.058.00
Only bulbs which meet or exceed NSF
standards, specifically designed for food
holding areas must be used. Breakage of bulbs
not specially coated could result in personal
injury and/or food contamination.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
This product has no "user" serviceable parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Parts when service is required.
it
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.
14
against injury
WARNING
WARNING
WARNING
WARNING
parts do not have
and food
the