Model Designation; Specifications; Plug Configurations - Hatco GR2SDH-24 Installation And Operating Manual

MODEL DESIGNATION

Glo-Ray
Designer
Sandwich
Display

SPECIFICATIONS

PLUG CONFIGURATIONS

Most units are supplied from the factory with an
electrical cord and plug attached. See Figure 4.
WARNING
Units supplied without electrical plug require
field installation of proper electrical plug. Plug
must be proper for the electrical specifications
of the unit and power supply and be grounded.
On units supplied without plug, connect the proper
plug to the cord, making sure the plug is rated for
the specific load and the plug matches a suitable
receptacle.
WARNING
For safe and proper operation, plug unit into a
properly grounded electrical outlet of the correct
voltage, wire size and plug configuration. If the
plug and receptacle do not match, contact a
qualified electrician to determine the proper
voltage and size and to install the proper
electrical outlet.
Form No. GR2SDM-0707
GR 2 S D H - 24 D
Figure 3. Model Designation
4
Dual Shelf
Heated Surface Width
H = Horizontal Shelf
S = Slant Shelf
*
NEMA 5-15P NEMA 5-20P
*
NEMA L14-20P
*
NEMA 14-20P
*
CEE 7/7 Schuko
Figure 4. Plug Configurations
*
Receptacle not supplied by Hatco.
* *
NEMA 5-30P
*
NEMA L14-30P
*
NEMA 14-30P
*
BS 1363